Filter
Top Products
– 69 –
Wireless remote controller (A-B selection)
Using 2 wireless remote controllers for the respec-
tive air conditioners, when the 2 air conditioners
are closely installed.
Wireless remote controller B setup
1. Start the air conditioner.
2. Point the wireless remote controller at the
indoor unit.
3. Push and hold
CHK
button on the wireless
remote controller by the tip of the pencil.
“00” will be shown on the display.
4. Push MODE
MODE
button during
CHK
pushing .
“B” will be shown on the display and “00” will be
disappear and the air conditioner will turn OFF.
The wireless remote controller B is memorized.
NOTE
• Repeat above step to reset wireless remote
controller to be A.
• The wireless remote controllers do not
display “A”.
• The factory default of the wireless remote
controllers is “A”.
• A-B selection can be set with signal receiving
unit.
For the further details, refer to the installation
manual.
PRESET FAN
"B" Display
"00" Display