Filter
Top Products
6
EN
Setting the clock
Before you start operating the air conditioner, set the clock of the remote control using the
procedures given in this section. The clock panel on the remote control will indicate the
time regardless of whether the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote control, the clock panel displays AM 0:00 and
flashes.
a ON button
Press the ON button to set the current time.
Each press of the ON button changes the time in one minute increments.
Holding down the ON button changes the time in ten minute increments.
b SET button
Press the SET button.
The current time is displayed and the clock starts.
Adjusting the clock
a CLOCK button
Press the CLOCK button.
The CLOCK indicator flashes.
b ON button
Press the ON button to set the current
time.
Each press of the ON button changes the
time in one minute increments.
Holding down the ON button changes the
time in ten minute increments.
c SET button
Press the SET button.
The current time is displayed and the clock
starts.
Preparing the filters
a Open the air inlet grille, and remove the air filters.
b Attach the supplied Zeolite-plus filter and
Zeolite-3G filter.
AUTO
PRESET
CLOCK
CHECK
FILTER
RESET
CLR
SET
SWING
FIX
FAN
ON
OFF
a
b
PAP
MODE
HiPOWER
ECO
MEMO
SLEEP
TEMP
1
.
3
.
5
.
9H
ON
ON
SET
SET
CLOCK
CHECK
FILTER
RESET
CLR
SET
SWING
FIX
FAN
ON
OFF
HiPOWER
ECO
MEMO
SLEEP
1
.
3
.
5
.
9H
AUTO
PRESET
CLOCK
CHECK
FILTER
RESET
CLR
SET
SWING
FIX
FAN
ON
OFF
a
b
c
PAP
MODE
HiPOWER
ECO
MEMO
SLEEP
TEMP
1
.
3
.
5
.
9H
Push CLOCK
ON
ON
SET
SET
Zeolite-3G filter
Zeolite-plus filter
01_EU_RAS-10JKP_EN.fm Page 6 Wednesday, April 9, 2003 8:08 AM