Filter
Top Products
22
EN
4 Wash and then dry.
(1) Soak in hot water at 40 to 50°C for about 10 to 15 minutes. If the staining is particularly
severe, use a washing detergent compound (weak basic or neutral) at 10 to 15 times
the standard concentration.
(2) Rub up and down, and rub left and right. Also, rub the surface gently with a sponge.
(3) Rinse with running water.
(4) Shake thoroughly, and allow the unit to drain.
(If oil or smoke strains are particularly hard to remove, repeat steps (1) to (4) two or
three times.)
(5) Allow to dry thoroughly in the shade.
5 Attach the dust collecting unit.
• Grasp the handles, and then insert as shown in a and b. Insert into the right and left
guide rails, and then press in the direction of b after it is all the way in.
• Press both ends of the dust collecting unit in the direction of c until the protrusions on
both sides of the dust collecting unit are completely inserted into the holders.
6 Attach the air filter, and then close the air inlet grille.
CAUTION
• Never use any products marked as “bleach”.
• Do not attempt to disassemble the unit.
• Do not rub with a scrubbing brush or similar implement.
• Do not dry with a hair dryer or other appliance that uses hot air. (The heat can cause the unit
to deform.)
• After cleaning, wait until the unit is completely dried before attaching. The FILTER indicator
may turn on if the unit is used while wet.
2
3
1
01_EU_RAS-10JKP_EN.fm Page 22 Wednesday, April 9, 2003 8:08 AM