Filter
Top Products
5
ENGLISHFRANÇAISDEUTSCHITALIANOESPAÑOLNEDERLANDSPORTUGUÊSΕΛΛΗΝΙΚΗ
EN
Display
All indicators, except for the clock time indicator, are displayed by pressing the button.
a Transmission mark
This transmission mark ( ) indicates when the remote control transmits signals to the indoor unit.
b Mode indicator
Indicates the current operation mode.
(AUTO: Automatic control, A: Auto changeover control, : Cool, : Dry,
:Heat)
c Temperature indicator
Indicates the temperature setting (17°C to 30°C).
d Air purifying indicator
Shows that the electrical air purifying operation is in progress.
e FAN speed indicator
Indicates the selected fan speed. AUTO or one of five fan speed levels (LOW ,
LOW+ , MED , MED+ , HIGH ) can be shown.
Indicates AUTO when the operating mode is either AUTO or : Dry.
f TIMER and clock time indicator
The time setting for timer operation or the clock time is indicated.
The current time is always indicated except during TIMER operation.
g Hi POWER indicator
Indicates when Hi POWER operation starts.
Press the Hi POWER button to start and press it again to stop operation.
h (MEMORY) indicator
Flashes for 3 seconds when the MEMO button is pressed during operation.
The mark is shown when holding down the button for more than 3 seconds
while the mark is flashing.
Press another button to turn off the mark.
i ECO indicator
Indicates when the ECO is activated.
Press the ECO button to start and press it again to stop operation.
j A. B change indicator remote control
Press the CHECK point and FIX button at the same time to change the remote
control setting from “A” to “B”. (Priority is given to the “A” setting.)
The E-Parts of the indoor unit are also changed to the “B” setting.
Loading the remote control batteries
a Remove the cover, and insert the batteries.
b Press the RESET button.
The clock indicator flashes.
Adjust the clock.
Reattach the cover.
Batteries
• To replace the batteries, use two new batteries (AAA type).
• The batteries will last about one year under normal usage.
• Replace the batteries if there is no receiving beep from the
indoor unit or when the air conditioner cannot be operated using
the remote control.
• To avoid malfunctions due to battery leakage, remove the
batteries when not using the remote control for more than one
month.
NAMES AND FUNCTIONS OF INDICATORS ON REMOTE
CONTROL
PREPARATION AND CHECK BEFORE USE
f
e
gi
c
ab
h
jd
• In the illustration, all indicators are shown
for purposes of explanation. During
operation, only the relevant indicators are
shown on the remote control.
CLOCK
CHECK
FILTER
RESET
CLR
SET
SWING
FIX
FAN
ON
OFF
b
HiPOWER
ECO
MEMO
SLEEP
1
.
3
.
5
.
9H
• Slide off the cover while pressing the sides.
• Battery replacement
Be careful not to reverse the (+) position and the (–)
position.
01_EU_RAS-10JKP_EN.fm Page 5 Wednesday, April 16, 2003 4:16 PM