Filter
Top Products
– 94 –
No. Part name Procedures
1) Follow to the procedure in the item .
2) Remove the two screws used to secure the
bearing base.
3) Remove the bearing base.
<Caution at assembling>
• If the bearing is out from the housing, push it
into the specified position and then
incorporate it in the main body.
Two screws
Bearing
Bearing base
Two
screws
Bearing
Bearing base
FILE NO. SVM-10020
One screw
Two screws
Exchanger lock
4) Remove three fixing screw at the right
side of the heat exchanger, and separate
the heat exchanger from the back body.
<How to assemble the heat exchanger>
Heat exchanger assembly on the back body,
and secure it using the fixing screw without
exchanger lock due to exchanger lock assemble
for protection affect when transpotation.
Bearing
Evaporator
(Heat exchanger)
(Figure 5)
(Figure 4, 5)
(Figure 4)
n
o