Filter
Top Products
– 93 –
No. Part name
Horizontal louver
Procedures
1) Remove shaft of the horizontal
louver from the back body.
(First remove the left shaft, and
then remove other shafts while
sliding the horizontal louver
leftward.)
Evaporator
(Heat exchanger)
1) Follow to the procedure in the item .
2) Remove the pipe holder from the rear side of the main unit. (Figure 1)
3) Remove two fixing screws at the left side of the end plate of the heat exchanger.
Remarks
Screw
Screw
FILE NO. SVM-10020
(Figure 1)
(Figure 2)
(Figure 3)
Pipe hoolder