Toshiba HWS-802XWHT6-E Heat Pump User Manual


 
109
Toshiba
3. Trial Operation
<Procedure>
A trial operation is available with an actual operation in progress or stopped. A trial operation is available in any of
the hot water supply, heating, or cooling mode. The compressor starts according to the trial operation frequency.
A trial operation automatically stops after 30 minutes at the longest if not stopped with the remote controller.
1 Press the remote controller TEST button for 4 seconds or
longer to display "TEST" on the LCD screen.
<For hot water supply trial operation>
2 Press the HOT WATER button, and a hot water supply
operation starts after 3 minutes. (See display )
(The pump immediately starts.)
3 Pressing the HOT WATER button again stops the hot
water supply operation.
<For heating trial operation>
1 Press the ZONE1,2 button, and a heating operation
starts after 3 minutes. (See display )
(The pump immediately starts.)
2 Pressing the ZONE1,2 button again stops the heating
operation.
<For cooling trial operation>
2 Press the ZONE1,2 button and then OPERATE MODE
, and a cooling operation starts after 3 minutes.
(The pump immediately starts.) (See display )
3 Pressing the ZONE1,2 button again stops the cooling
operation.
4 Press TEST on the remote controller to exit the trial
operation mode.
1, 4 2, 3
1, 4 2, 3
1, 4 3 2
+00A09-002_01EN_SVM_ALL_Air_to_Water.book Page 109 Monday, October 5, 2009 2:09 PM