Filter
Top Products
102 ESV4 User’s Manual
*Once motion detection is enabled in this page, please configure the
motion area and enable motion detection in the corresponding
channels (cameras) from camera's own web UI. The NVR only detects
the first motion area set in the camera. The NVR recognizes the first
motion area by its ID number set in the camera.
Define which system events should trigger the recorder to send out
notifications.
Define how the notifications will be sent and where they will be sent to.
* Event trigger may not work for cameras that are placed outside of
your local network or on the Internet until the “UPnP Port Forwarding”
is enabled in both the NVR and the router.
NVR Setup -- Recording Configurations (Web
Interface)
General Settings
The “recording configurations” gives users the overall control of how
and when a recording is performed and the quality of different types of
recordings performed on each channels. It can help the recorder to
operate with sufficient system resource by performing recording only
when it’s necessary with adjustable recording frame rate.