Filter
Top Products
The following watering control features enable you to fur-
ther control the watering program during operation.
All watering control features apply to watering programs
started manually
and automatically.
To Pause Watering
Press the +/ON and –/OFF buttons at the same time.
• The station currently watering will shut off.
• The “Watering On” symbol will begin flashing.
• The display will show the amount of run time remain-
ing for the paused station.
Note: If watering is not resumed within 8 minutes, all
watering operations will be canceled and the con-
troller will return to the automatic mode.
To Resume Watering (when paused)
Press the NEXT button.
• Watering activity will resume from the point of inter-
ruption.
To Cancel Watering
Press the +/ON and –/OFF buttons at the same time -
two times
.
• All watering operations will be canceled and the con-
troller will return to the automatic mode.
Note: Placing the control dial in the OFF position for
two seconds, then back to
RUN will also cancel all
watering operations.
To Skip Stations
Press the NEXT button one time.
• The station currently watering will shut off and the
next station will start.
• If the last station is skipped, the program will end. If
additional programs have been set to operate the
next program in alphabetical order will start.
To Adjust The Station Run Time
Press the +/ON button to increase run time or the –/OFF
button to decrease run time.
• If the station run time is decreased to less than
1 minute, the station will shut off. The next station in
sequence will start.
• The station run time is changed during this operation
only. The program memory will not be changed.
Watering Control Features
28