Filter
Top Products
2
EUTECTIC EC-10 DV
Maximum operating pressure 60 psi.
All boilers h
ydrostatically tested — A.S
.M.E.
* For forced hot water heating systems where the boiler and all piping are
located within the area to be heated, the boiler may be selected on the basis
of D.O
.E.
capacity output.The net I=B=R output ratings shown are based on
an allowance for piping and pickup of 1.15 (water). D.O.E. capacity output is
divided by the allowance to obtain net rating. The Slant/Fin Technical Service
department should be consulted before selecting a boiler for unusual piping
and pickup requirements such as intermittent system operation, extensive
piping, etc.
† Ratings apply to the use of light oil at 140,000 Btu per gallon and apply only
when b
ur
ner models listed on pages 8 of this manual are used, and are
properly adjusted to produce 13% CO
2
.
#
All dimensions subject to nor
mal man
ufacturing tolerance.
NOTE: All boilers under 300,000 Btuh (87.9 kw) input are tested and rated for
capacity under the U.S. Department of Energy (D.O.E.) Test Procedures for
Boilers.
TABLE 1: Ratings and Dimensions
EC-13DV 0.65 91,000 79 69 87 36 22-1/4 27 5 11-13/16 2
EC-14DV 0.80 112,000 98 85 87 41 27-1/4 32 5 16-13/16 2
EC-15DV 1.00 140,000 123 107 87 46 32-1/4 37 5 21-13/16 2
EC-16DV 1.15 161,000 141 123 87 51 37-1/4 42 6 26-13/16 4
BOILER
MODEL
NO.
GPH BTUH
I=B=R
BURNER
CAPACITY
OIL INPUT †
D.O.E.
HEATING
CAPACITY
MBH *
WATER
APPROX.
OVERALL
LENGTH
“A”
I=B=R
WATER
NET
RATING
MBH *
DIMENSIONS (inches) #
AFUE %
BOILER
LENGTH
“B”
BOILER
LENGTH
“C”
FLUE
DIA.
“D”
DISTANCE
BETWEEN
LEGS
“E”
FLUE
OUTLET
LENGTH
“F”
Figure 1: Dimensions (inches)
1
-1/4 threaded
s
upply
Flue outlet øD
1
-1/4 threaded
r
eturn pipe
D
rain outlet
R
elief valve 3/4’’
Supply Pipe Mounted
T
ridicator
P
anel Mounted
Tridicator Pressure
Sensor Well
Panel Mounted
Tridicator Temperature
S
ensor Well
A