Filter
Top Products
20
A D V A N C E D
CHECKING THE PROGRAM
VIEW SEGMENT
The View Segment feature is used to view which segment of the program the kiln is currently running. This feature is
particularly useful when used in conjunction with the Skip Segment function to determine that the correct segment is cur-
rently running. It is also helpful if you are trying to determine if the kiln is in a heating segment or a cooling segment.
While the kiln is fi ring
Press
. If the kiln is in a heating portion of the program the display will read “rA”, which
stands for rate, along with the segment number. For example “rA2” would mean that the program is in the heating portion of
segment 2.
If the program is in a Hold portion of the segment it will read “HLd” along with the segment number.
Immediately following the segment display will be EdIt (Edit Mode is described in the Advanced Programming sec-
tion). This is for accessing the Advanced Edit Mode. The display will then go back to displaying the current kiln tempera-
ture.
REVIEW
Review is helpful to verify which program is running or was run last.
Press
while the kiln is running or in Idle
mode to activate the Review Feature. The display will list the Rate, the Process, the Process Temperature, and the Process
Hold Time.
When Review is activated while the kiln is fi ring it will return to displaying the kiln temperature. If Review is acti-
vated while in IDLE Mode it will place the controller in Ready Mode after the Review process is complete. At this point you
may press start to start the program or wait for the kiln to revert to Idle Mode.
ADVANCED PROGRAMING