Filter
Top Products
14
B E G I N N E R
STEP 1 - START IN I
D
LE STATE
To start programming the kiln must be in an IdLE state. This can be verifi ed by the display alternating between the cur-
rent temperature and the message IdLE. When the kiln is fi rst plugged in it will read “PF” indicating that there was a power
interruption. To return to IDLE Mode
Press
rent temperature and the message IdLE. When the kiln is fi rst plugged in it will read “PF” indicating that there was a power
Press
once you are in IDLE Mode to begin the programming process.
STEP 2 - SELECT FIRING MODE
To Display Current Firing Mode Press
The display will read either “AUTO” or “PRO”. If the display reads “AUTO” it is currently set in the GlassFire
Mode.
Press
to select this mode..
If the display reads “PRO” it is currently set in the Ramp and Hold Mode. Press
or
to scroll to “AUTO”.
Press
to select this mode.
STEP 2 - SELECT SPEED
The controller will display the current fi ring
speed. The display will read SLo, MEd, or
FASt for slow, medium, or fast heating rates.
Use the chart to the right to help select the
appropriate speed for the size of your project.
Press
or
to scroll to the desired fi ring
speed.
Press
to select the displayed heating rate.
STEP 3- SELECT PROCESS
Next the controller will display the current
process. The display will read
SLP
,
tAC
, or
FULL
for slump, tac-fuse, or full-fuse pro-
cesses.
Press
or
to scroll to the desired
Process.
Press
to select the displayed Process.
FAST
1/8” Thick - 18” diameter or smaller
1/4” Thick - 4” diameter or smaller
3/8” Thick - Not recommended
MEDIUM
1/8” Thick - 20” diameter or smaller
1/4” Thick - 8” diameter or smaller
3/8” Thick - 5” diameter or smaller
SLOW
1/8” Thick - 24” diameter or smaller
1/4” Thick - 18” diameter or smaller
3/8” Thick - 12” diameter or smaller
1/2” Thick - 8” diameter or smaller
BASIC FIRING STEPS
2 - AUTO MODE (GLASSFIRE)
The GlassMaster LT controller is designed with the beginning fuser in mind. It is important to have a good
general understanding of the principals of glass before programming your kiln. Therefore we recommend reading the
General Firing Guidelines section of this manual before programming the kiln.
For a metric conversion of this chart visit
our website at http://www.skutt.com/glass/
products/hotstart.php