Singer 1004 Sewing Machine User Manual

To remove the extension bed from the machine, hold it firmly and pull it toward the left.
Once removed, you will have access to the free arm. This allows you to sew pants or
sleeve hems, as well as other hard-to-reach areas.
The inside of the removable extension bed can be used to store the machine's accessories.
To open the accessory storage compartment, flip the cover down, as shown.
To install the removable extension bed, hold it in your left hand and push it firmly toward
the right. It is helpful to place your right hand at the right side of the machine to stabilize it
as you push the extension bed in place.
Connect the machine to a power source, as illustrated.
This machine is equipped with an electric plug that must be used with the appropriate
power outlet.
Unplug the power cord when the machine is not in use.
For machines with a polarized plug (one blade is wider than the other), the plug is
intended to fit in a polarized outlet only one way. If it does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
To turn the machine on to sew, use the Power On/Off & Speed Control Switch.
Set it in the “L” position in order to sew at slower speeds, or set it at the “H” position in
order to sew at higher speeds.
When the machine is threaded and ready to sew, lower the presser foot and step on the
foot controller. The machine will sew according to where you have set the Power On/Off
& Speed Control Switch.