Filter
Top Products
(5)(6)
RAISING THE BOBBIN THREAD
CHOOSING A STITCH PATTERN
The Pattern Selector Dial is used to select the stitch you want to sew. The numbers on the
dial directly correspond to the display on the front of the machine. Simply turn the dial until
the number of the stitch that you want to sew lines up with the red dot marking above the
dial.
STRAIGHT STITCHING
The straight stitch is the most frequently used stitch for all types of sewing.
1.To begin sewing, first raise the presser foot lifter.
2.Pull both the upper thread and the bobbin thread under the presser foot toward the
back of the machine, leaving about 6” of thread.
3.Place the fabric under the presser foot, then lower the presser foot lifter.
4.Turn the hand wheel counter-clockwise (toward you) until the needle enters the fabric.
5.Start the machine by stepping on the foot controller. Guide the fabric with your hands.
When reaching the edge of the fabric, stop the sewing machine.
6.Turn the hand wheel counter-clockwise (toward you) until the needle is in its highest
position, then raise the presser foot lifter.
7.Draw the fabric to the rear and cut off excess thread with the thread cutter, located on
the side of the machine, as shown.
18
17
THREADING THE UPPER THREAD
(2)(1)
(3)
(4)
Before you start to sew, it will be necessary to draw up the bobbin thread.
Raise the presser foot lifter.
Holding the needle thread loosely with your left hand, turn the hand wheel toward you
(counter-clockwise) with your right hand, first lowering the needle and continuing until
the needle comes to its highest position.
Lightly pull up the top thread, and pick up the bobbin thread, which will appear through
the needle plate slot.
Pull both the top and bobbin thread together toward the back of the machine, under the
presser foot, leaving about 6” clear.
Replace the bobbin cover plate.
(7)
(8)
(5)
(6)
(3)
(2)
(4)
(1)