Filter
Top Products
5, 6, 8, 10 Stitch Sewing Machines
Winding a bobbin
Winding a bobbin is quick and easy when you follow
the directions below. Always wind the bobbin before
threading the machine and needle.
* Push in indent (1) on hand wheel disc. This will stop
the needle from moving.
* Place spool of thread on spool pin.
* Slide spool cap (2) firmly over rim of spool to prevent
thread tangling.
* Lead thread from spool and snap into thread guide
post (3).
* Wind thread clockwise around front of bobbin winder
tension disc (4).
* Pass thread end, from inside, through small hole in
rim of bobbin.
* Place bobbin on spindle and push it to the right
* Holding thread end, step on speed controller to run
machine until desired amount of thread is wound.
(Winding stops automatically once bobbin is full.)
* Cut thread; push bobbin to the left and remove it
from spindle.
* Trim thread end from top of bobbin.
* Return hand wheel disc to sewing position by
pressing on side opposite indent.
14