Filter
Top Products
6
7
Operation Operation
Note: Follow these instructions for best results.
• Place unit at least 7 feet from equipment that
emits electric waves such as televisions or radios.
• Place unit at least 2 feet from the wall.
• Keep sensors away from drafty areas.
• Keep
curtains away
from sensors, as they may
interfere with air intake/outlet.
• Place unit on
a stable surface with plenty of air
circulation.
To set-up cleaner:
• Remove protective film from the control panel.
• Remove the fr
ont panel by grasping the bottom
outside edges and gently pulling toward you.
• Pull out the filter cassette by grasping the tabs
located on each side of the filter cassette.
• Remove the plastic wrap from the filter cassette.
• Return the filter cassette into the main unit.
• Replace the fr
ont panel by hooking the front panel
on the top of the unit. Swing panel in by pushing
gently until the panel snaps into place.
• Plug in the power cord to a wall outlet.
• Press power button until short “beep” is heard.
Note: For the first 4 minutes after turning the unit
on, the dust and odor indicators will flash while
the unit measures air quality.
1.
Ti
mer - Press the TIMER button once
for
1 hour of operation; press the button
a second time for 4 hours; press a third
time for 8 hours. Pressing the TIMER
button a fourth time returns to the Off
Timer mode.
2
.
Function - Press the FUNCTION button
once to set the unit to Auto. Continue
to press the button for Sleep > Low >
Medium > High > Return to Auto.
3
.
Dust & Odor Sensors - Automatically
monitor air quality and adjust fan speed.
4
.
Change Filter Indicator - The
indicator will signal when to replace the
filter cassette.
5.
Auto Mode - T
he unit is set to
default to Automatic operation when
it is first turned on. Smart sensors will
automatically sense the amount of
impurities in the air, and adjust the fan
speed accordingly.
6
.
PlasmaWave Indicator - Turn on
the Plasma generator by pressing
the PLASMA ON/OFF button on the
remote. PlasmaWave generates both
positive and negative ions to produce
hydroxyl radicals that inactivate airborn
contaminants.
7
. Light Sensor - Automatically activates
Sleep mode when room is darkened.
8
.
Fan Speed Indicator - Shows current
fan speed setting.
9
.
Sleep - The unit will work on Ultra-Quiet
mode and dim the control panel lights.
10
. A
uto Sleep Mode - Use the TIMER
button on the display or remote to
manually turn the light sensor on or off.
With the light sensor on, the unit will
automatically operate in Sleep mode
when the room is dark. When the
room is light, the unit will revert to its
previous settings. Sleep mode provides
the lowest, quietest fan setting and a
dimmed display panel.
1
1. T
imer - Indicates timer setting or
continuous mode.
12
.
Power Button - Turn unit on and off by
pressing the POWER button. Holding
the button down for 2-3 seconds turns
the Plasma generator on or off.
1
2
3 3
5
6
8
9
11
12
4
7 10
Display Panel
SV-HH_Manual_4.06.indd 6-7 5/1/06 7:22:04 PM