Filter
Top Products
26
27
Problem Solving Guide
Trouble Shooting
PROBLEM
Vacuum won’t turn on
Vacuum won’t pick up or
low suction
Dust escaping from vacuum
POSSIBLE REASON
• Power cord not rmly
plugged in
• Blown fuse or tripped
breaker
• Needs service
• Vacuum bag full
• Clogged lter
• Hose clogged
• Worn brushroll
• Broken belt
• Dust cover not installed
properly
• Filter not installed
correctly
• Vacuum bag not installed
correctly
POSSIBLE SOLUTION
• Plug unit in rmly
• Check house fuse or
breaker. Replace fuse /
reset breaker.
• Take to Authorized Retailer
(1-888-9-SIMPLY)
• Install new bag
• Install new lter
• Remove obstacle
• Replace brush strips
• Replace belt
• Reinsert the dust cover
and secure latch
• Review lter installation
(page 19)
• Review bag installation
(page 18)
Any other service should be done by an
Authorized Service Representative.
Service 1-888-9-SIMPLY
To locate your nearest retailer, visit our website at
www.simplicityvac.com
Problem Solving Guide
Thermal motor protection
Your Symmetry is equipped with a
safeguard to recognize when the vacuum
heats up and shuts itself down to protect
your vacuum cleaner. Note that when this
happens, the headlight is still on but the
motor shuts off. Common reasons why a
vacuum may overheat include operating a
vacuum with a full bag or when there is a
clog in the vacuum.
• Unplug the vacuum.
• Inspect your vacuum for a full bag
condition or a hose clog and correct
the problem. Locate the Thermal Motor
Reset button on the back of the vacuum.
Press button and resume vacuuming.
If problem continues, contact your
Authorized Simplicity Retailer.
Thermal Reset
If problem persists,
consult owner’s manual
or contact retailer.
1. Unplug machine
2. Locate problem
source (clogged
hose or full bag)
3. Correct problem
4. Press reset button
1. Unplug machine
2. Locate problem
source (clogged
hose or full bag)
3. Correct problem
4. Press reset button