Filter
Top Products
20
21
Replacing the secondary filter
The secondary lter protects the motor
from dust and dirt. Before installing a new
vacuum bag, check the lter. Accumulated
dirt in the bag compartment will be
collected on this lter and may restrict
motor performance when the lter
becomes dirty.
• Open the bag compartment lid and locate
the secondary lter on the bottom of the
bag compartment.
• Remove secondary filter from the bottom
of the bag compartment.
• The foam secondary filter can be washed
and reused. If washed, make sure the
filter is completely dry before reinstalling.
The charcoal secondary filter cannot
be reused (models SYMPNT & SYMP).
Remove and throw away the used
charcoal secondary filter.
• Insert the new filter by sliding it under
the bag support.
• Close the bag compartment lid.
Maintenance and Care Maintenance and Care
Removing and reinstalling bottom plate
CAUTION: Disconnect the vacuum cleaner
from the electrical outlet before removing the
bottom plate.
• Depress handle release pedal twice and
place the vacuum cleaner in the low
position.
• Turn vacuum cleaner over, exposing the
underside.
• Slide locking latch to the right.
• Press tabs inward on each side and pull
bottom plate off.
• Reinstall by placing lower edge of bottom
plate along lower edge of nozzle. Snap
plate into place. Slide locking latch to the
left to secure.
NOTE: To ensure maximum cleaning
efficiency, the condition of the belt should
be checked regularly. If belt is stretched,
cracked or if excessive slipping is
occurring, replace the belt.