Filter
Top Products
INSTALLATION INSTRUCTIONS CEILING BRACKET AN-CM270
C A U T I O N
C A U T I O NC A U T I O N
C A U T I O N
INSTALLATION OF THIS ADJUSTABLE WALL MOUNTING BRACKET
SHOULD BE PERFORMED BY QUALIFIED SERVICE/INSTALLATION
PERSONNEL FOLLOWING THE INSTALLATION INSTRUCTIONS
INCLUDED WITH THIS BRACKET
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE
IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT
OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE.
IMPORTANT! THE INSTALLER SHOULD READ THESE INSTRUCTIONS THOROUGHLY
BEFORE BEGINNING THE INSTALLATION AND SHOULD MAKE SURE THAT ALL
THE WORK IS DONE IN COMPLIANCE WITH NEC AND ALL LOCAL BUILDING
AND SAFETY CODES. SAVE THIS BOOKLET AFTER THE INSTALLATION IS
COMPLETED. THE ACCESSORIES REFERRED TO IN THESE INSTRUCTIONS ARE
INTENDED FOR USE ONLY WITH COMPATIBLE SHARP PROJECTORS. SEE
SHARP PROJECTOR OWNER’S MANUAL OR SHARP DEALER TO DETERMINE
SUITABILITY.
CAUTION: THE BRACKET MOUNTING SCREWS MUST GO DIRECTLY INTO THE
BEAMS. SHEETROCK, LATH AND PLASTER, WILL NOT PROVIDE A
SUFFICIENTLY SECURE SUPPORT.
CAUTION: TO REDUCE THE RISK OF PERSONAL INJURY, USE ONLY THE
COMPONENTS WHICH ARE INCLUDED IN THIS PACKAGE, OR SPECIFIED IN
THESE INSTRUCTIONS.
PARTS LIST FOR MODEL AN-CM270 CEILING BRACKET (SEE FIG. 1)
ITEM DESCRIPTION QUANTITY
A. PROJECTOR ATTACHMENT PLATE WHICH INCLUDES THE KNUCKLE
POSITIONING ASSEMBLY. 1
B. LOCKING HEX NUT & WASHER 1
C. STEEL CEILING MOUNTING PLATE 1
D. PLASTIC TRIM FOR CEILING PLATE 1
E. 1/4 X 10 HEX HEAD LAG BOLTS 2-1/2” LONG 6
F. 1/4 X 10 HEX HEAD LAG BOLTS 3” LONG 6
G. 1/4” I.D. WASHERS FOR USE WITH LAG BOLTS 6
H. M4 X 12mm FLAT HEAD MOUNTING SCREWS FOR USE WITH ATTACHMENT PLATE 3
I. M4 X 12mm KNURLED THUMB SCREW 1
J. M4X30mm FLAT HEAD SCREW 1
K. PLASTIC TRIM COLLAR 1
PAGE 2