Filter
Top Products
Quick Start
TOLL FREE: 1-800-798-7398
ASSEMBLE
1 Fit together the extension tubes
as shown in the illustration.
See page 2 for more detailed
assembly instructions.
2 Place the micro-fiber cleaning
cloth underneath the mop head,
with quick fastener strips facing
up. Simply press the pad to the
mop to attach it.
ADJUST
4 For your comfort, you can adjust
the height of the mop. Just lift
the latch on the tube 90 degrees
to the open position. Holding
the handle, extend the tube to
the height that’s right for you
and then close latch to locked
position.
QUICK TIP: If you find the Steam
Mop difficult to push/pull during
use, then simply increase the
height of the pole.
PRIME STEAM
5 Plug in the mop. Wait 30 seconds
for the unit to heat up and the
steam to be ready.
Push the handle toward the mop
head in a pumping motion. To
prime simply pump the handle
10-15 times to generate the
steam.
QUICK TIP: Customize steam
output by slow or fast mopping
with a forward and backward
motion.
Quick Start
www.sharkclean.com
FILL
3 Remove the cap to fill the
Water Tank. Using the filling
flask and funnel, fill the tank,
keeping the water under the
“MAX FILL” line. Don’t forget to
replace the cap.
1
2
4
3
5
S3101_SERIES-S3202_SERIES_11_ENG_IB_100909.indd 4-5 08/09/10 4:33 PM