Filter
Top Products
8
Putting the diversity receiver into operation
̈ Lift one side of the belt clip Ƽ as shown.
̈ Press down the belt clip Ƽ at one fixing point and pull it out of the
receiver housing.
̈ Repeat for the other side.
̈ Place the perforated plate ƹ onto the rear of the receiver.
̈ Reinsert the belt clip Ƽ.
̈ Use one of the supplied line cables to connect the line input of the
camera to the socket³.
The ground connection of the line cable serves as the antenna for
the second diversity section. For details on the connector assign-
ment, refer to the diagram on page 24.
Ƽ
³