Filter
Top Products
9
Using the diversity receiver
Using the diversity receiver
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see next section).
2. Switch a transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the receiver’s RF level display
“RF” ቢ reacts.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter “Synchronizing a transmitter with the diversity
receiver” on page 19.
Switching the diversity receiver on/off
̈ Push the two battery compartment catches µ and open the battery
compartment cover ¾.
To switch the diversity receiver on:
̈ Press the ON/OFF button ¹.
The red ON LED » lights up and the standard display “Frequency/
Name” appears on the display panel.
To switch the diversity receiver off:
̈ Keep the ON/OFF button ¹ pressed until “OFF” appears on the display
panel.
The red ON LED » goes off and the diversity receiver switches off.
It is vital to observe the notes on frequency selection on page 19.
When in the operating menu, pressing the ON/OFF button ¹ will
cancel your entry (ESC function) and return you to the current
standard display.
¹
»
¾
µ
µ