Filter
Top Products
ENFORCER Delayed Egress Timer
SECO-LARM U.S.A., Inc 7 SECO-LARM U.S.A., Inc. 33 7
Lock Status Jumper:
When the lock status jumper is ON, the lock status
input will detect whether the door is closed and will
trigger relock functions.
The lock status input may be bypassed in order to
keep the door unlocked for an indefinite period of time
without activating the remote alarm output.
To bypass the lock status input, set jumper 1 to OFF.
The lock status input must be ON for BOCA Mode
(See pg. 5, Relock Modes).
Jumper 1
Jumper 2
Jumper 3
Default: OFF
Default: OFF
The SA-025EQ is equipped with a 500mA@12VDC
transistor ground output for a local alarm, typically an
audible or visual device.
The local alarm output can be set for steady or
pulsing. When set ON, the local alarm pulses during
the pre-delay, gradually pulsing faster until the end of
the pre-delay time. The local alarm will continue
signaling steady 5 seconds after the lock has been
released. When set OFF, the local alarm is steady
during the pre-delay time and for 5 seconds after the
lock has been released.
LED 4 is on when the local alarm output is active.
The local alarm signals when the pre-delay bypass
is used (see pg. 9).
To set the local alarm output type ON (steady) or
OFF (pulsing), use jumper 3 on the right side of the
circuit board.
Local Alarm Output Type Jumper:
Security Mode Jumper:
To activate security mode, set jumper 2 to ON.
In security mode, after the initiate device (such as a
push-to-exit bar) has been triggered and the
pre-delay timer has ended, the lock will remain active
until the initiate device has been triggered a second
time.
When security mode is OFF, the initiate device must
only be activated once.
Default: OFF