Filter
Top Products
11
VACUUM MAINTENANCE
Changing the Filter Bag - Figures 22, 23, 24, 25 & 26
To change the filter bag (40), switch off the power and unplug the vacuum. Lift the cover
release catch (#15, figure 22) and raise the filter bag cover (18). Seal the filter bag with
the sealing cap (49). Lift the filter bag out of the holder by tilting the green collar (50)
u
p and pulling it out of the holder as shown in figure 23.
Insert the green collar of a new filter bag down into the filter bag holder vertically as
shown in figure 25. Line up the tabs (#52, figure 24) with the slots on the green collar
(#51, figure 26) and gently push the collar down flat until the center U-shaped clip (#53,
figure 24) moves all the way forward. Close the cover, making sure it snaps shut com-
pletely. Do not re-use the filter bags.
The “bag full or clog” indicator works correctly only at full power. Check the status of the
filter bag regularly at full power.
Note: The nature of the contents of the filter bag will affect the point at which it needs
changing. Fine dust may require an earlier change even though the bag is not full. Fluff
or hair allows air to pass through easily, so the filter bag may over fill before the “bag
full” indicator turns orange.
Figure 27
Always unplug vacuum from outlet
before dismantling any part of machine!
!
Changing the AIRBELT - Figure 27
If damage occurs to the AIRBELT cover, it will need to be replaced. To remove
the AIRBELT (7), pry off the clip (23) by inserting the tip of a slot-head screw-
driver under the bottom side of the clip. Push outward carefully on the screw-
driver until the clip pops off. Grasp the end of the AIRBELT cover (7) and pull -
the AIRBELT cover will peel off. The foam bumper (54) remains on the vacuum.
To replace the AIRBELT, insert the side ribs of the AIRBELT into the grooves
(55). Start at the back, insert the rib of the AIRBELT cover into one groove (55),
and while holding it down, stretch the AIRBELT cover around the foam (54) into
the opposite groove (55). Continue around the vacuum. Secure the ends with
the clip (23).
SEBO AIRBELT covers are available in a variety of colors and patterns. See
your SEBO dealer for available selection.
Note: Never operate the vacuum with incorrectly attached filters or without filters, bag, AIRBELT or filter bag housing cover
(18). Do not re-use filter bags. Do not wash and re-use filters.
AIRBELT Cover - Part #6047AM/01-08
Figure 24
7
54
23
55
54
55
49
51
51
40
50
Figure 22
15
18
Figure 23
49
40
Figure 25
Filter Bags
Filterbox D
Part #8120AM
Figure 26
52
53
50