Sears 139.53971SRT Garage Door Opener User Manual


 
Using the Wall.Mounted Door Control
Press the lighted push
button to open or close the
door. Press again to reverse
the door during the closing
cycle or to stop the door
while it's opening.
LIGHTEb
PUSH BUTTON
i LIGHT
--. :BUTTON
!, -- - LOCK
BUTTON
THE PREMIUM CONTROL CONSOLE
Light feature
Press the Light button to turn the opener light on or
off. It will net control the opener light when the door is
in motion. If you turn it on and then activate the
opener, the light will remain en for 4-1/2 minutes.
Press again to turn it off sooner.
Lock feature
Designed to prevent operation of the door from hand-
held remote controls. However, the door will open
and close from the Door Control, the Outdoor Key
Switch and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2
seconds. The push butten light will flash as long as
the Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds. The push button light will stop flashing.
The Lock feature will also turn off whenever the SRT
(Smart Receiver/Transmitter) button on the motor unit
panel is activated.
To Open the Door Manually
To preventpossibleSERIOUSINJURYor DEATHfrom
afalling garagedoor:
If possible,useemergencyreleasehandleto
disengagetrol]ey ONLYwhen garagedoor is
CLOSED.Weakor brokensprings or unbalanced
door couldresult in an opendoor falling rapidly
and/or unexpectedly.
- NEVERuseemergencyreleasehandleunlessgarage
doorwayis clearof personsand obstructions.
NEVERusehandleto pull door openor closed.If rope
knotbecomesuntied,you could fall.
DISCONNECT THE TROLLEY:
The door should be fully closed
if possible. Pull down on the
emergency release handle (so
that the trolley release arm
snaps into a vertical position)
and lift the door manually. The
lockout feature prevents the
trolley from reconnecting
automatically, and the door can
be raised and lowered manually
as often as necessary. Lockout
Trolley
Trolley -- .J
Release art[
(In Manual
Disconnect
Position)
_osition
(Manual disconnect)
TO RE-CONNECT THE TROLLEY:
Pull the emergency release
handle toward the opener at
a 45° degree angle so that
the trolley release arm is
horizontal. The trolley will
reconnect on the next UP or
DOWN operation, either
manually or by using the
door control or remote.
Trolley
_p_ulir_Yn dn_
To reconnect
32