Filter
Top Products
OPERATION
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of severe injury or death:
1. READANDFOLLOWALL WARNINGSAND
INSTRUCTIONS.
2. ALWAYSkeepremotecontrols outof reachof children.
NEVERpermitchildrento operateor play with garage
door control push buttons or remotecontrols.
3. ONLYactivategaragedoor when it canbeseenclearly,it
is properlyadjusted,and thereare no obstructionsto
door travel,
4. ALWAYSkeepgaragedoor in sight until completely
closed.NOONESHOULDCROSSTHEPATHOFTHE
MOVINGDOOR.
5. If possible,use emergencyreleasehandleto disengage
trolley ONLYwhengaragedoor is CLOSED.Weakor
broken springsor unbalanceddoor couldresult Lnan
opendoor falling rapidlyand/or unexpectedly.
6. NEVERuseemergencyreleasehandleunlessgarage
doorwayis clear of personsandobstructions,
7. NEVERusehandleto pull garagedoor openor closed. If
ropeknot becomesuntied, youcould fall.
8. If onecontrol (forceor travel limits) isadjusted,the
other control mayalso needadjustment.
9. Afterany adjustmentsare made,the safetyreversal
system MUSTbetested.
10. Safetyreversalsystem MUSTbetestedeverymonth.
Garagedoor MUSTreverseon contactwith one-inch
high object(or a 2x4 laidflat) onthe floor.
11. ALWAYSKEEPGARAGEDOORPROPERLYBALANCED
(seepage3), An improperlybalanceddoor maynot
reversewhenrequiredand couldresult in severeinjury
or death.
12. All repairsto cables,spring assembliesandother
hardware,allof which areunderEXTREMEtension,
MUSTbe madeby a traineddoor systemstechnician.
13. ALWAYSdisconnectelectricpowerto garagedoor
openerbefore makinganyrepairsor removingcovers.
14SAVETHESEINSTRUCTIONS.
Using Your Garage Door Opener
Your opener and hand-held remote control have been
factory-set to a matching code to operate with the
large push button. Your opener will operate with as
many as four "SRT" (Smart Receiver/Transmitter)
hand-held remote controls and one Multi-function
Keyless Entry. However, you can use either of the
two small buttons, if you prefer. And, the 3-function
remote control can also activate additional garage
door openers and/or light controls. If you purchase a
new remote, or if you wish to deactivate any remote,
follow the instructions in the Programming section.
Activate your opener with any of the following:
• The hand-held Remote Control: Holdthe large
push button down until the door starts to move.
• The wall-mounted Door Control: Hold the push
button down until the door starts to move.
• The Keyless Entry (See Accessories): If supplied
with your garage door opener, it must be
programmed before use. See Programming,
When the opener is activated (with the safety
reversing sensor correctly installed end aligned)
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door wig stop.
4. If the door has been stopped in a partially open
position, it will close.
5. if obstructed while closing, the door will reverse. If
the obstruction interrupts the sensor beam, the
opener light will blink for five seconds.
6. If obstructed while opening, the door will stop.
7. If fully open, the door wig not close when the beam
is broken. The sensor has no effect in the opening
cycle.
If the sensor is not installed, or is misaligned, the
door won't close from a hand-held remote. However,
you can close the door with the Door Control, the
Outdoor Key Switch, or Keyless Entry, ifyou activate
them until down travel is complete. If you release
them too soon, the door will reverse.
The opener light will turn on under the following
conditions: when the opener is initially plugged in;
when power is restored after interruption; when the
opener is activated.
It will turn off automatically after 4-1/2 minutes or
provide constant light when the Light feature on the
Premium Control Console is activated. Rulb size is
75 watts maximum.
31