Filter
Top Products
PROGRAMMING
NOTICE: If this Security.l_ garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security+ ®remote controls.
To Add or Reprogram a Hand.held Remote Control
USING THE "LEARN" BUTTON USING THE MOTION DETECTING CONTROL
CONSOLE
o
1. Press and release the "learn" button
on the motor unit. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
\1 /
1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the
Motion Detecting Control Console.
3. Continue holding both buttons while
you press the push bar on the Motion
Detecting Control Console (all three
buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote, first erase all
codes:
Press and hold the learn button on motorll[_ [ III
unit until the learn indicator light goes out I_l_ III
(approximately 6 seconds). All previous I I l' li III
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
*3-Function Remotes
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any Security+ ®
3-Function remote or
compact remote can be
programmed to operate
other Security+ ®garage
door openers.
35