Filter
Top Products
INSTALLATION STEP 2
Install the Header Bracket
You can attach the header bracket either to the wall above
the garage door, or to the ceiling. Follow the instructions
which will work best for your particular requirements. Do
not install the header bracket over drywall. If installing
into masonry, use concrete anchors (not provided).
WALL HEADER BRACKET INSTALLATION
• Center the bracket on the vertical centerline with the
bottom edge of the bracket on the horilontal line as
shown (with the arrow pointing toward the ceiling).
• Mark the vertical set of bracket holes. Drill 3/16" pilot
holes and fasten the bracket securely to a structural
support with the hardware provided.
HARDWARE SHOWN ACTUAL SIZE
Lag Screw
5/16" 9xl 5/8"
Wail Mount
Optional
Mounting Holes
Header
Vedical
Centefline
of Garage Door
Lag Screws
5/16"x9x1 5/8"
Horizontal / / /
Line /
/Gar
/ S age
/ -- Door --
J
Highest Point of
Garage Door Travel Vedical
Centefline
of Garage Door
CEILING HEADER BRACKET INSTALLATION
• Extend the vertical centerline onto the ceiling as shown.
• Center the bracket on the vertical mark, no more than 6"
(15 cm) from the wall. Make sure the arrow is pointing
away from the wall. The bracket can be mounted flush
against the ceiling when clearance is minimal.
• Mark the side holes. Drill 3/16" pilot holes and fasten
bracket securely to a structural support with the
hardware provided.
Ceiling Mounting Holes
/.; _/ i
Finished
Ceiling
.. ___" J _ Vertical Centedine
. - of Garage Door
/
Header _
Bracket /_
6" (15 cm) Maximum
Door
Spring m Lag Screws
-_ 5/16"x9x1 5/8"
13