Filter
Top Products
OPERATION
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
1. READAND FOLLOWALL WARNINGSANDINSTRUCTIONS.
2. ALWAYSkeepremote controls out of reachof children.
NEVERpermit children to operateor play with garagedoor
control push buttons or remotecontrols.
3. ONLYactivategarage door when it can be seenclearly, it is
properly adjusted andthere are noobstructions to door
travel.
4. ALWAYSkeepgarage door insight until completely closed.
NOONESHOULDCROSSTHE PATHOFTHE MOVING
DOOR.
5. NOONESHOULDGOUNDERA STOPPED,PARTIALLY
OPENEDDOOR.
6. If possible, useemergency releasehandleto disengage
trolley ONLYwhen garagedoor is CLOSED.Weak or broken
springs or unbalanceddoor could result in an opendoor
failing rapidly and/or unexpectedly.
7. NEVERuseemergency releasehandle unless garage
doorway is clear of persons and obstructions.
8. NEVERusehandle to pull garagedoor open orclosed. If
rope knot becomesuntied, you could fall.
9. If one control (force or travel limits) is adjusted,the other
control mayalso needadjustment.
10. After ANYadjustments are made,the safety reversal
system MUSTbe tested.
11. Safetyreversalsystem MUSTbetested every month.
Garagedoor MUSTreverseon contactwith 1-1/2" high
(3.8 cm) object (ora 2x4 laid flat) on the floor.
12. ALWAYSKEEPGARAGEDOORPROPERLYBALANCED(see
page3). An improperly balanceddoor may not reverse
when required and could result in SEVEREINJURYor
DEATH.
13. ALL repairsto cables,spring assemblies and other
hardware,ALL of which are under EXTREMEtension,
MUSTbe made bya trained door systems technician.
14. ALWAYSdisconnect electric power to garagedoor opener
BEFOREmaking any repairs or removing covers.
SAVETHESEINSTRUCTIONS.
Using Your Garage Door Opener
Your Security+ ®opener and hand-held remote control
have been factory-set to a matching code which changes
with each use, randomly accessing over 1OObillion new
codes. Your opener will operate with up to eight Security+ ®
remote controls and one Security+ ®Keyless Entry System.
If you purchase a new remote, or if you wish to deactivate
any remote, follow the instructions in the Programming
section.
Activate your opener with any of the following:
• The hand-held Remote Control: Hold the large push
button down until the door starts to move.
• The wall-mounted Door Control: Hold the push button or
bar down until the door starts to move.
• The Keyless Entry (See Accessories): If provided with
your garage door opener, it must be programmed before
use. See Programming.
When the opener is activated (with the safety
reversing sensor correctly installed and aligned)
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop.
4. If the door has been stopped in a partially open position,
it will close.
5. If obstructed while closing, the door will reverse. If the
obstruction interrupts the sensor beam, the opener lights
will blink for five seconds.
6. If obstructed while opening, the door will stop.
7. If fully open, the door will not close when the beam is
broken. The sensor has no effect in the opening cycle.
If the sensor is not installed, or is misaligned, the door
won't close from a hand-held remote. However, you can
close the door with the Door Control, the Outdoor Key
Switch, or Keyless Entry, if you activate them until down
travel is complete. If you release them too soon, the door
will reverse.
The opener lights will turn on under the following
conditions: when the opener is initially plugged in; when
power is restored after interruption; when the opener is
activated.
They will turn off automatically after 4-1/2 minutes or
provide constant light when the Light feature on the Motion
Detecting Control Console is activated. Bulb size is A19.
Bulb power is 100 watts maximum.
Security+ _light feature: Lights will also turn on when
someone walks through the open garage door. With a
Motion Detecting Control Console, this feature may be
turned off as follows: With the opener lights off, press and
hold the light button for 10 seconds, until the light goes on,
then off again. To restore this feature, start with the opener
lights on, then press and hold the light button for 10
seconds until the light goes off, then on again.
30