Filter
Top Products
33
Adjust Force - SEARS
Bouton
"SRT" (intelligent)
Ouvre-porte de garage
(avec bouton "SRT")
Témoin
PANNEAU
ARRIÈRE
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
"SRT" (learn)
Button
Garage Door Opener
(With "Smart" Button)
Indicator
Light
BACK
PANEL
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
On trouvera également les instructions
de programmation des codes sur
le panneau arrière.
Code programming instructions are
also located on the back panel.
Figure 2
Select a remote control push
button to operate opener
SECURITY✚
3-Function
Remote Control
Choisir un bouton-poussoir
pour faire fonctionner l'ouvre-porte
SECURITY✚
Télécommande à
3 fonctions
Figure 1
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause serious
injury or death.
Do not allow children to operate
the door push button(s) or remote control(s).
A moving garage door could injure or kill
someone under it.
Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
Your garage door opener receiver and remote control
have been pre-set at the factory. The door will open
when you press the LARGE remote control push
button. THE CODE BETWEEN THE REMOTE
CONTROL AND THE RECEIVER CHANGES WITH
EACH USE, randomly accessing over 100 billion new
codes.
The 3-function remote control can also activate
additional SECURITY✚ garage door openers and/or
light controls.
Your SECURITY✚ opener will operate with:
• several SECURITY✚ remote controls (with blue
push buttons) utilizing up to 8 functions.
• one SECURITY✚ Keyless Entry System (Model
18795).
Follow the instructions below to program your opener
to match any additional remotes you may purchase.
See Accessories on page 38.
To Add A Remote Control
1.Press and
hold
the selected remote control push
button. See Figure 1.
2.Then press and release the SRT (learn) button on
the back panel of the opener, Figure 2. The
indicator light on the back panel will begin to blink
and the opener light will
flash once.
3.Release the remote push button.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the SRT button on the opener panel
until the indicator light turns off (about 6 seconds). All
remote control codes are now erased. Then follow
the steps above to re-program each remote control.
To Add the Keyless Entry
We recommend that you program your password
before you install the Keyless Entry. You will not
need assistance, and you can test the reception
at the mounting location before installation.
1. Choose a 4-digit password using numbers from
0 to 9 (a number can be used more than once, for
example, 4, 0, 4, 1).
2. Press the four buttons for the password, then
press and
hold
the Enter button. The indicator
light on the door opener back panel will blink.
3. Press and release the SRT (learn) button on the
opener panel. After the opener light flashes,
release the Enter button.
Test by pressing the password, then press Enter.
The door should begin to move.
WARNING
CAUTION
WARNING
AVERTISSEMENT
ATTENTION
AVERTISSEMENT
WARNING
AVERTISSEMENT
Receiver and Remote Control Programming
To comply with FCC/IC rules, adjustment or modifications of this receiver
and/or transmitter are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.