Filter
Top Products
The Chamberlain Group, Inc.
Step 7 Install Light and Lens - Sears
4/17/92 - 4/20/92
Lens Guide
Lens Slot
75 Watt Max.
Light Bulb
Lens Tab
Light Lens
Guides
du diffuseur
Encoche
du diffuseur
Ampoules de 75
watts maximum
Patte du diffuseur
Diffuseur
Install the light:
• Install a 75 watt maximum light bulb in each
socket. The lights will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the lights will turn OFF.
• If the bulbs burn out prematurely due to vibration,
replace them with standard neck "Garage Door
Opener" bulbs.
Install the lens:
• Apply slight pressure on the sides of each lens
and slide the tabs into the slots in the side panels.
• For convenience, the lens may be installed
after Adjustment Step 4 on page 30.
• Reverse the procedure to remove the lenses.
Installation Step 7
Install the Light and the Lens
6. Attach the User Safety Instruction label to the wall
near the door control, and the Maintenance
Instruction label in a prominent location on the
inside of the garage door.
Page 32 explains how to use the door control.
Do NOT connect the power and operate the
opener at this time.
The trolley will travel to the
full
open
position but will not return to the
close
position until the sensor beam is
connected and properly aligned.
See Safety Reversing Sensor instructions
beginning on page 21.
Installation Step 8
Attach the Emergency
Release Rope and Handle
Do not use the red handle to pull the door
open or closed.
The rope knot could become
untied and you could fall.
Use the emergency
release only to disengage the trolley and, if
possible, only when the door is closed.
Garage doors are heavy. If the door is open
when the handle is pulled, the door could
close inadvertently if it is not properly
balanced. Serious injury may result to persons
under the door. Make sure the doorway is clear
of persons and obstructions before pulling
handle when door is open.
• Thread one end of the rope through the hole in
the top of the red handle so "NOTICE" reads right
side up as shown. Secure with an overhand knot.
The knot should be at least 1" from the end of
the rope to prevent slipping.
• Thread the other end of the rope through the hole
in the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above
the floor. Secure with an overhand knot .
If it is necessary to cut the rope, heat seal the
cut end with a match or lighter to prevent
unraveling.
Step 5 Attach Emergency Release Rope & Handle - SEARS 315-699 (Yellow Disk #2)
Models 53315, 53415, 53515, 53625 & 53699
6/20/89 - 6/27/89
Overhand
Knot
Trolley
NOTICE
Emergency
Release Handle
Rope
Overhand
Knot
Trolley
Release Arm
Trolley
Emergency
Release Handle
Rope
Overhand
Knot
Trolley
Release Arm
NOTICE
Overhand
Knot
19
WARNING
CAUTION
WARNING
AVERTISSEMENT
ATTENTION
AVERTISSEMENT
WARNING
AVERTISSEMENT