Sears 139.18847 Garage Door Opener User Manual


 
To open the door
manually:
The door should be fully
closed if possible. Pull
down on the red
emergency release
handle and lift the door
manually. To reconnect
the door to the opener,
press the Door Control
push button.
32
Activate the opener with any of the following:
The Remote Control: Hold push button down until
the door starts to move.
The Door Control: Hold push button down until
the door starts to move.
The Outdoor Key Switch or Keyless Entry: (See
Accessories)
When the opener is activated with the safety
reversing sensor installed and correctly aligned:
1. If open, the door will close. If closed, the door will
open.
2. If closing, the door will reverse.
3. If opening, the door will stop (allowing space for
entry and exit of pets and for fresh air).
4. If the door has been stopped in a partially open
position, it will close.
5. If obstructed while closing, the door will reverse.
6. If obstructed while opening, the door will stop.
7. The garage door will reverse in the closing cycle
when the invisible beam is broken. If fully open,
the door will not close when the beam is broken.
The sensor has no effect in the opening cycle.
If the sensor is not installed, or is not aligned
correctly, the door won't close from any remote
transmitter. You can close the door with the Door
Control, the Outdoor Key Switch, or Keyless Entry,
however, if you activate them
until down travel is
complete
. If you release them too soon, the door will
reverse.
The opener light will
blink for 5 seconds
when the
safety reversing sensor causes the door to reverse.
Opener Light will turn on under the following
conditions: When the opener is initially plugged in;
when the power is interrupted; when the opener is
activated. They will turn off automatically after 4-1/2
minutes or provide constant light when the Light
feature is activated. SECURITY
models: Lights will
also turn on when someone walks through the open
garage door. Bulb size is 75 watts maximum.
The lockout feature
prevents the trolley from
reconnecting auto-
matically. Pull the
emergency handle down
and back (toward the
opener). The door can
then be raised and
lowered manually as often
as necessary. To
disengage the Lockout
Feature, pull the
emergency handle straight
down. The trolley will
reconnect on the next UP
or Down operation.
Trolley
Trolley
Release Arm
NOTICE
Emergency
Release Handle
(Pull Down & Back
Towards Opener)
Manual Disconnect and Lockout
Sears -92
9/7/90, 3/2/92
Trolley
Trolley
Release Arm
NOTICE
Emergency
Release Handle
(Pull Down)
Trolley
Trolley
Release Arm
Trolley
Trolley
Release Arm
NOTICE
Emergency
Release Handle
(Pull Down & Back
Towards Opener)
Manual Disconnect and Lockout
Sears -92
9/7/90, 3/2/92
Trolley
Trolley
Release Arm
NOTICE
Emergency
Release Handle
(Pull Down)
Trolley
Trolley
Release Arm
Lockout position
Manual disconnect
position
Weak or broken springs could allow an open
door to fall (either rapidly or unexpectedly),
resulting in serious injury, death or property
damage.
If possible, use the emergency
release rope and handle
only
when the door is
fully closed.
Operation of Your Opener
WARNING
CAUTION
WARNING
AVERTISSEMENT
ATTENTION
AVERTISSEMENT
WARNING
AVERTISSEMENT
Press the lighted push button to open or close the
door.
Press again to
reverse
the door during the closing
cycle or to
stop
the door while it's opening.
Operation of the Door Controls
(see page 18)