Filter
Top Products
SC
94
How to check for overlapping of central address Nos.
(1) Press the and buttons at the same
time for more than 4 seconds.
and CODE No. C1 will flash.
(2) Select CODE No. C3 by pressing ,
( ) button and press the button.
C3 changes from flashing to ON state and
will flash. Then auto overlap checking will start.
(3) If C3 changes from ON to flashing and
stops flashing and disappears, there is no over-
lapping.
Then finally, complete the auto overlap checking
mode by pressing the
button.
(4) If some of GROUP No., ZONE No. and UNIT No.
flash, you should try the zone registration again.
Select CODE No. C1 by pressing ,
( ) button and press the button.
Select the flashing GROUP No. with the ZONE
and GROUP buttons.
Then press the button and reselect the
ZONE, GROUP and UNIT No.
Then finally, complete the auto overlap
checking mode by pressing the
button.
Fig. 8-11
1
2
3
07-115 SSHP_II 5/7/07 4:00 PM Page 94