Filter
Top Products
45
A
Hook
Screw
Hinge
Intake grille
Slide
Press on the tabs with a flathead (minus)
screwdriver while pulling out the intake grille.
Screw
Removing the intake grille
Slide the intake grille hooks (2
locations) in the direction of the
arrow to open the intake grille.
(Fig. 3-72)
When the intake grille is open,
press a flathead screwdriver against
the rear tabs (2 locations) and pull
out the intake grille. (Fig. 3-73)
Removing the side panel
Grasp the finger grip on the side
panel and slide the panel in the
direction of arrow
1
to remove the
panel. (Fig. 3-74)
(There are 2 panels: 1 each on the
left and right sides.)
Side panel
Slide
Tab
1
Fig. 3-72
Fig. 3-73
Fig. 3-74
3-19-2. Installing the ceiling panel
(1) Fasten the hooks on both sides of the ceiling panel to
the indoor unit. The hooks on one side (2 locations)
are stationary, while the hook on the other side is
moveable. (Fig. 3-75)
(2) Angle the panel somewhat and fasten the stationary
hook into the fastener on the side of the unit.
(3) After verifying that the hook is fastened, press the
other end up until the ceiling panel is level. Then
press upwards until the moveable hook is fastened
into the fastener on the unit.
(4) Verify that the hooks on both sides of the ceiling
panel are securely fastened to the unit. If the hooks
are not securely fastened, the panel may fall. At this
point, the panel is now provisionally fastened to the
unit.
●
When removing the panel, press the movable hook
toward the inside while supporting the panel.
(Fig. 3-76)
Stationary hook
Press to remove.
Moveable hook
Moveable hook
Hook receiver
Fig. 3-75
Fig. 3-76