Sanyo 85464369098000 Air Conditioner User Manual


 
103
T
Air intake grill
finger-hold
Air filter
Air intake grill
Air filter finger-hold
Latch
Air filter finger-hold
* Take hold of the finger-hold on the air filter, pull it toward you.
Hook
Screw
Slide
Screw
<How to remove the filter>
1. Take hold of the finger-hold on
the air intake grille and press
it to the rear, and the grille will
open downward.
2. Take hold of the finger-hold on
the air filter, pull it toward you.
9-4. Ceiling-Mounted Type (T Type)
NAME OF PARTS
CARE AND CLEANING
CEIL ING- MO UNTED
T t y pe
Wa t e r d r a i n
Air intak e
grille (air
inta ke)
Air outlet
(Drain pipe can be
connected to either
the left or right side.)
CAUTION
WARNING
1. For safety, be sure to turn the air conditioner off and also to disconnect the power before
cleaning.
2. Do not pour water on the indoor unit to clean it. This will damage the internal
components and cause an electric shock hazard.
1. Never use solvents or harsh chemicals when cleaning the indoor unit. Do not wipe plastic
parts using very hot water.
2. Some metal edges and the fins are sharp and may cause injury if handled improperly; be
especially careful when you clean these parts.
3. The internal coil and other components must be cleaned regularly. Consult your dealer or
service center.
Air intake and outlet side Clean the air intake and outlet side of the indoor unit with a vacuum cleaner brush, or wipe them
(Indoor unit) with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with water. When cleaning the air outlet
side, be careful not to force the vanes out of place.
Air filter
The air filter collects dust and other particles from the air and should be cleaned at regular intervals
as indicated in the table below or when the filter indication (
) on the display of the remote control
unit (wired type) shows that the filter needs cleaning. If the filter gets blocked, the efficiency of the air
conditioner drops greatly.
<How to clean the filter>
Type Period
T 2 weeks
NOTE
The frequency with which the filter should be cleaned depends on the environment in which the
unit is used.
1. Remove the air filter from the air intake
grille.
2. Use a vacuum cleaner to remove light
dust. If there is sticky dust on the filter,
wash the filter in lukewarm, soapy water,
rinse it in clean water, and dry it.