Filter
Top Products
1. Pull zipper down
3. Pull bag throat
off sleeve
6. Roll up coil spring
7. Place paper bag into outer bag
NOTE: Be certain there are no
folds at the top or bottom of the
paper bag
8. Lift zipper
5. Place bag throat
on sleeve
How To Change Disposable Dust
Bag – Style F & G (Some models only.)
2. Roll down
coil spring
4. Unfold new bag
TOP
BOTTOM
{
Look for the symbol.
Ask for GENUINE EUREKA dust bags–Style F & G.
GENUINE
EUREKA PRODUCT
6
THROAT
How to Replace A Worn Belt
CAUTION: Turn off the switch and unplug the
electrical cord before replacing belt.
Belt pulleys can become hot during
normal use. To prevent burns, avoid
touching the belt pulley when servicing
the drive belt.
IMPORTANT: Improper installation of the brush roll
or brush roll belt could cause carpet
or cleaner damage.
1. Release cam locks to remove
bottom plate.
2. Pull up on belt to rotate it off the
motor pulley. Lift up on brush
roll and remove worn belt.
3. Place new belt around brush roll.
4. Align brush roll pulley with belt guide.
5. Place rubber end cap covers
over both end caps (flat side
against end cap). Align holes
and secure.
6. Align end caps with slots in
cleaner base. Push brush roll
into base.
Belt
guide
Fan Cover
Motor Pulley
Brush Roll Pulley
7. Place lower side of belt into
belt guide and pull to stretch
the belt around the left side of
motor pulley. Rotate pulley to
secure belt into groove.
8. Place slots of bottom plate
over tabs of cleaner base.
Seat and secure cam locks
(refer to 1).
Ask for GENUINE EUREKA replacement belts - No. 52100.
Look for the symbol.
8 8
GENUINE
EUREKA PRODUCT
Brush Roll Belt
The brush roll belt on the upright vacuum cleaner drives the
brush to agitate, sweep, and comb the carpet nap. The belt
should be checked regularly to be sure it is in good condition.
Replace the belt if it is stretching, cracking, or slipping. Cut away
any hair or thread wound around the brush roll or the belt pulley
because the buildup could cause the belt to rotate unevenly.
Brush Roll
The rotating brush roll sweeps and combs the carpet nap. Keep
the brush roll free from hair and threads so it will continue brushing
the carpet nap. Replace worn brush strips when the bristles
no longer touch a straight edge held across the bottom plate.
There are two types of brush rolls, the chromed steel tubular
brush roll or the anodized aluminum spiral brush roll. Follow
the instructions for the type of brush roll featured on the cleaner.
CAUTION: Turn off the switch and unplug the
electrical cord before replacing brush
strips.