Samsung SCV-2080R Home Security System User Manual


  Open as PDF
of 19
 
COLOR DOME CAMERA User Guide
10
COLOR DOME CAMERA User Guide
11
Installation
Installation
Adjust the panning, tilting and rotate mechanism while checking the position on the monitor
1) Remove the dome cover and shield case from the main body by loosening the three
dome cover screws.
2)
And then remove the main body from the mounting bracket by the four main body screws.
MountingBracket
MainBody(Camera)
DomeCover
73°
-170°
145° 195°
170°
PanBase
Tilt Base
RotateBase
• The installation should be done by qualified service personnel or system installers.
• If the ceiling material is not strong enough to hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
• Take care not to drop the product during installation. Do not allow anyone to stand below the
installation area.
Notes
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
•PanBasemovesby170°toeachdirectionand340°onthewhole.
•TiltBasecoverstotal146°angle(73°toeachside).
•TheanglerangeoftheRotateBaseisthesameasthatofthePanBase.Butone
directionrangeis195°andanotheris145°
2) Methods of adjustment
•Wallinstallation
After mounting the camera to the wall, loosen the rotate base holding screws.
Adjust to the correct panning angle.
Then adjust the tilt angle by rotating the base.
Once complete re-tighten the rotate base holding screws.
•Ceilinginstallation
After mounting the camera to the ceiling, loosen the rotate base holding screws.
Adjust to the correct panning angle.
Then adjust the tilt angle by rotating the base.
Once complete re-tighten the rotate base holding screws.
• When adjusting the rotating angle, loosen rotate base holding screw as follows Figure A. And
then tighten it again.
• When adjusting the tilting angle, grip the tilt base and adjust tilting angle.
• When adjusting the panning angle, loosen pan base holding screws as the follows Figure B.
And then tighten them again.
• The 2 LED sections can be tilted inside the case to a maximum angle of 73°, this however
will not alter the illuminated range.
Notes
• When adjusting the tilt mechanism hold the Tilt base and NOT the lens.
Rotate Base Holding Screw
Pan Base Holding Screw Rotate Base Holding Screw
 previous next