Filter
Top Products
18
Installation Checklist
A. Water Heater Location
B. Water Supply
C. Gas Supply
D. Relief Valve
E. Venting
❑ Close to area of vent termination.
❑ Indoors and protected from freezing
temperatures.
❑ Proper clearance from combustible surfaces
observed and water heater not installed on
carpeted floor.
❑ Sufficient fresh air supply for proper
operation of water heater.
❑ Air supply free of corrosive elements and
flammable vapors.
❑ Provisions made to protect area from water
damage.
❑ Sufficient room to service heater.
❑ Combustible materials, such as clothing,
cleaning materials, rags, etc. clear of the base
of the heater.
❑ Clearances of 1” (2.54cm) from combustion
air inlet openings observed.
❑ Water heater completely filled with water.
❑ Air purged from water heater and piping.
❑ Water connections tight and free of leaks.
❑ Gas line equipped with shut-off valve, union
and sediment trap.
❑ Approved pipe joint compound used.
❑ Soap and water solution used to check all
connections and fittings for possible gas leak.
❑ Gas Company inspected installation (if
required).
❑ Temperature and Pressure Relief Valve
properly installed and discharge line run to
open drain.
❑ Discharge line protected from freezing.
❑ Vent length verified.
❑ Heater vented separately from all other
appliances.
❑ Proper materials and techniques used in vent
assembly.
❑ Vent pipe properly secured to blower
housing.
❑ Vent termination/screen installed.
❑ Vent pipe supported at required intervals.
❑ Appropriate minimum clearance observed.
❑ Precautions taken to prevent moisture
damage around vent termination.
F. Wiring
❑ Correct power supply (120V) 50/60 Hz.
❑ Electrical Connections tight.
❑ Heater properly ground and proper polarity
observed.