Royal Consumer Information Products G31 Indoor Fireplace User Manual


 
DESCRIPTION
This Royal Cozy Fires Decorative Fuel Effect gas fire has been developed to give a realistic coal burning
appearance with the instant control and convenience of gas. The fire has been constructed to enable it to be
installed into applications where the warmth and comfort of an open fire and high radiant heat is required.
This appliance is intended for decorative purposes, the coal bed uses ceramic simulated coals to give a
realistic appearance and to allow secondary air to be entrained into the bed to ensure clean combustion. An
aerated single port steel burner is used running parallel across the front of the fire. A single gas control with a
variable high to low setting is used with a Flame Supervision Device (FSD). This is fitted to ensure that
should the pilot flame be extinguished for any reason, (including turning off the appliance), the gas supply to
the burner is cut off until a full lighting sequence is repeated. A separate Piezo igniter is used to ignite an
Oxy/pilot sensor (O.D.S) that will cause the appliance to ‘shut off’ in the event of continued spillage
occurring under hazardous or blocked flue conditions. The fire bed consists of ceramic fibre components and
coals all of that are removable for cleaning purposes when required. It is important when relaying the coal bed
and coals to follow the instructions correctly.
This appliance is suitable for installations into the following flues:
7" minimum diameter flues (CLASS 1),
5" minimum diameter flues (CLASS 2),
Pre-cast flues to BS 1289 Pt 1 1986
The installations must always be used in conjunction with a suitable hearth and surround. .
TECHNICAL DATA
Overall height of fire = 602 mm
Overall width of fire = 505 mm
Minimum height of opening required = 550 mm
Minimum width of opening required = 396 mm
Forward projection from opening = 50 mm
(without front & fret)
Depth behind opening = 122 mm
TYPE OF GAS G31 Only
Supply Pressure 37 mbar +/- 1mbar (Cold)
GAS INPUTS (Gross)
Max 6 kW (20470 Btu/h)
Min 3.5kW (11940 Btu/h)
Pilot 0.26 kW ( 890 Btu/h)
Main Injector Type
Stereomatic 046-19-196-047M
Pilot
OP. Oxy/Pilot 1PG 9214
GAS CONNECTION
8mm O/D Tube
WEIGHT 11.5 kg without front & fret 14.5 kg with front & fret.
Page 2