Filter
Top Products
This Royal Cozy Fires Decorative Fuel Effect gas fire has been developed to give a realistic coal burning
appearance with the instant control and convenience of gas. The fire has been constructed to enable it to be
installed into applications where the warmth and comfort of an open fire and high radiant heat is required. This
appliance is intended for decorative purposes, the coal bed uses ceramic simulated coals to give a realistic
appearance and to allow secondary air to be entrained into the bed to ensure clean combustion. An aerated single
port steel burner is used running parallel across the front of the fire. A single gas control with a variable high to
low setting is used with a Flame Supervision Device (FSD). This is fitted to ensure that should the pilot flame be
extinguished for any reason, (including turning off the appliance), the gas supply to the burner is cut off until a
full lighting sequence is repeated. A separate Piezo igniter is used to ignite an Oxy/Pilot sensor (ODS) which will
cause the appliance to ’shut off’ in the event of continued spillage occurring under hazardous or blocked flue
conditions. The fire bed consists of ceramic fibre components and coals all of that are removable for cleaning
purposes when required. It is important when relaying the coal bed and coals to follow the instructions correctly.
TECHNICAL DATA
TYPE OF GAS G31 only
SETTING PRESSURE 37 mbar +/- 1 mbar (cold)
GAS INPUTS (Gross) Max 6 kW (20470 Btu/h)
Min 3.5 kW (11940 Btu/h)
Pilot 0.26 kW (890 Btu/h)
IMPORTANT NOTES
This appliance is intended for decorative purposes, it is designed and manufactured to the requirements of the BS
5258 Pt 16: 1991 and is for use on Propane Gas Only.
All gas appliance installations must be carried out by a competent person in accordance with the Gas Safety
(installation & Use) Regulations 1994 (as amended) or the rules in force and in accordance with the Manufacturers
Installation Instructions. Failure to comply could lead to prosecution.
The chimney or flue (unless new) must be swept before installation. It is recommended that the appliance be
serviced annually by a competent person and that the flue is checked for satisfactory clearance of products and
there is no excessive build up of soot. The curing effect of heating the coals will cause an initial odour which,
although not harmful, may require additional ventilation until the odour has disappeared.
Ventilation is required for this appliance with a minimum cross sectional area of 100 sq. cms and should be
checked regularly to ensure that it is free from obstruction.
The appliance has a naked flame, a fireguard conforming to BS 6539 or BS 6778 should be used for the
protection of the very young, elderly and infirm. Combustible materials should not be put on or left in the hearth
nor should the coal bed be used to burn rubbish or other materials.
Care must be taken on the selection of wall coverings within close proximity of the fire as some vinyl and
embossed materials may be become discoloured by convected heat. Soft furnishings must be kept clear from the
radiant heat of the fire and from impinging the hearth area. The hearth must not be covered by any combustible
materials such as carpets etc.
This product uses fuel effect pieces, gaskets and insulation material containing Refractory Ceramic Fibre
(RCF), which are man-made vitreous silicate fibres. Excessive exposure to these materials may cause
temporary irritation to eyes, skin and respiratory tract, consequently, it makes sense to take care when handling
these articles to ensure that the release of dust is kept to a minimum.
This fire will run for 2.2 hours on one kilogram of gas with the gas control on the high setting.
Page 2