Filter
Top Products
1. Press and hold SET button while pressing PROG/MAN button. Release
both buttons.The display will show the time clock setting:
2. Press either ∨ or ∧ button to adjust the current time forward or
backward. The time will change in one-minute increments each time
you press either button. The time will scroll in 10-minute increments if
you hold down either button. Note AM/PM indicator.
3. Press SET button. The day of the week will appear at the top of the
display.
4. Press either ∨ or ∧ button to change to the current day of the week
(MON, TUE, WED, THU, FRI, SAT, SUN).
11
PM
MON
PROGRAMMING
Set or Change Time, Day, Temp. Differential, and Residual Cooling
NOTE: During programming, the setting to be changed will appear on the display. If no key presses are made within 45
seconds, the display will revert to the main display. Press PROG/MAN button at any time during programming to return to the
main display.
SET
PROG/MAN
SET
PROGRAMMING
24V AC Circuit Power Monitor
If you experience a loss of power, this thermostat will indicate “-AC” in the time field of the LCD
display. This means that your system’s 24 V AC circuit is not receiving power or is not functioning
correctly. The back-up batteries provided in this thermostat will maintain the programming during
the loss of power, however, the thermostat requires 24V AC power and a functioning system for
proper control.
LED Indicators
There are three LED indicators located on the front of your Robert Shaw thermostat. They are designed to
inform you of the following:
AUX (GREEN): This turns on when the auxiliary (also called back-up) heating is in
operation. This is the second (non-economy) stage of heat.
CHECK (RED): When this turns on, a malfunction has occurred somewhere in the heat
pump system. Please contact a qualified service technician as soon as
possible to check your system.
EMER (RED): This light turns on whenever the emergency heat is manually selected
(system is in the EMER mode). While in the emergency heat mode, the
heat pump compressor is off, and the emergency heat (same as the
auxiliary heat) maintains the setpoint temperature.
30
OPERATION