Filter
Top Products
– 4 –
DIMENSIONS
21 13/16" (554mm)
19 15/16" (506mm)
8 7/16"(214mm)
Power supply cable
29 1/2" (750mm)
8 9/16"
(217mm)
9 5/8"
(245mm)
Exhaust at rear of unit
3 7/16" (88mm)
11 " (280mm)
R8.0"
(R206mm)
R11"
(R279mm)
1"
(25mm)
3"
18"
Gas Inlet
3 3/8" (85mm)
6 1/2" (165mm)
GENERAL INFORMATION
THIS SERIES HEATER IS DESIGN CERTIFIED BY CSA
INTERNATIONAL AS A DIRECT VENT WALL FURNACE AND
MUST BE INSTALLED ACCORDING TO THESE INSTRUCTIONS.
ALTERATION OF THE ORIGINAL DESIGN INSTALLED OTHER
THAN AS SHOWN IN THESE INSTRUCTIONS OR USED WITH
A TYPE OF GAS NOT SHOWN ON THE RATING PLATE, IS
THE RESPONSIBILITY OF THE PERSON AND COMPANY
MAKING THE CHANGE.
Rinnai is continually updating and improving products. Therefore, specifications are subject to
change without notice.
Thank you for purchasing Rinnai forced flue gas heater.
Please read the warranty thoroughly and keep it in a safe place.
22. If a blockage occurs at vent terminal due to snow, leaves or other type of obstruction the unit will
stop working. The unit will not function until blockage has been removed then if unit fails to operate,
contact a qualified service agency.
23. For a manufactured home (USA only) or mobile home OEM or residential or light commercial installation, this
unit has been designed and certified to be converted from natural gas to propane or vice-versa. When
provisions are being made to convert this unit, a certified conversion kit must be used. You must also
readjust manifold gas pressure to specifications indicated in the conversion manual. If in doubt, contact
Rinnai America for assistance.