Filter
Top Products
4
USERS INSTRUCTIONS
The following instructions are designed for the user of the water heater.
The user may not install or adjust the appliance in any way that requires the removal of
the front of the unit. To remove the front cover of the unit you must be certified compe-
tent to do so. Information for the Installer is given on page 22.
All work done on this appliance must be done by a qualified gas en-
gineer. A qualified gas engineer must carry an up to date CORGI
Registered Gas Installer picture identification card while working
on gas appliances. If you are unsure do not be afraid to ask the en-
gineer to show you the card. If you are still not satisfied call CORGI
on 0870 401 2300 and verify the engineers name with their data-
base. This is for your own safety.
Responsibilities of the USER
The user must abide by all warnings given in this book. The user must only reference
the user section of the book, and may not carry out any procedure listed in the installer
section.
The user must have the unit checked and maintained annually by a gas engineer.
The user must periodically check the water filter on the inlet to the appliance.
The user must not use the appliance in any way that it was not meant to be used. The
user may only use the heater as detailed in the User portion of this manual.
The user must not store or use any flammable vapours or liquids in the vicinity of this or
any other appliance.
The user should familiarise themselves with the water heaters gas service valve and the
main gas valve to the premises.
IF YOU SMELL GAS
Isolate the gas supply and get out of the building.
Do not try to light any appliance.
Do not turn any light or other electrical switch on or off.
Do not use any telephone in the building.
Call your gas engineer from a safe location and follow their
instructions.
If you cannot reach your gas engineer ring the following:
TRANSCO 0800 111 999