Filter
Top Products
4
5
Description of the Extractor
• The machine is shipped fully assembled and
is ready for use.
• Adjust handle from transport position. To
adjust, while standing behind the machine
lift handle to desirable operating height. Turn
right knob forward while turning left knob
backward to tighten handle in operating
position (fig 1).
• Hinge open cover and remove recovery tank
from machine. Make sure the float shut-off
screen and filter are in place before use.
• Using a clean bucket, ll solution tank
with 15L (4 gal) of hot water, 60°C (140°F)
maximum (fig 2). Observe solution tank hose
at rear of machine when filling. The hose
indicates the amount of water in solution tank.
Do not use recovery tank to fill machine. Use
a clean bucket.
• Replace recovery tank and close cover
after filling.
• Plug machine’s power cord into a grounded
wall outlet.
At tention: Do not use recovery tank to fill
solution tank. Residual dirt or debris could
cause damage to solution pump.
Warning: Flammable materials can cause
an explosion or fire. Do not use flammable
materials in tank(s).
For Safety: When using machine, follow
mixing and handling instructions on Riccar
chemical containers.
Note: Use Riccar Extractor Detergent only.
Before Using Your Extractor for the First Time
5
10
11
2
4
3
1
12
1 Main on / off power switch
2 Pump reset button
3 Brush reset button
4 Power cord hooks
5 Solution button
6 Folding handle
7 Recovery tank cover
8 Recovery tank
9 Solution tank
10 Accessory hose coupler
11 Accessory hose port
12 Nozzle
13 Folding handle lock knob
14 Solution tank drain hose
6
7
8
9
13
13
13
14
Figure 1
Figure 2