Filter
Top Products
16 E33 FPI Direct Vent Gas Insert
INSTALLATION
1) Remove the rivets from the surround by
pulling off the hoseclamp (located at the
backside of surround) with a screwdriver or
plyer. Re-install the rivets by putting them
through the holes on the sides of the sur-
round.
3) Remove the handles by removing the nut
and screw. Install the new handles by plac-
ing them in position over the holes on the
surround louver. Put the screws through
the holes and secure them by tightening
them with a nut.
2) Take the hoseclamps and put them over the
back of each rivet. Squeeze the hoseclamp
to secure onto rivets ensuring that the
hoseclamp is touching the back side of
the surround. The hoseclamp can now be
released.
4) Place the emblem over the emblem design
on the surround. Insert the studs through the
holes. To secure them fi rst put on the split
lock washer and then the nut and tighten.
DOUBLE DOOR OPTION
Remove the handles by removing the nut
and screw. Install the new handles by plac-
ing them in position over the holes on the
door(s). Put the studs through the holes
and secure them by tightening them with a
nut.
5) Place the bottom hooks of the Surround into
the bottom slots of the Faceplate. Slightly
pull up the Surround and push the top hooks
into the top slots of the Faceplate. Push
down to secure. Tug on the Surround to
ensure it is securely locked in place.
Backside of
Surround Shown
Hooks
Faceplate Slots
Surround
Faceplate
ACCENT KIT
INSTALLATION
5) Remove the 2 studs on the sides of the Hood.
Insert the new studs through the holes and
secure them by fi rst putting on the washer
and then tighten with a nut.
OPTIONAL SCREEN
DOORS
1) Attach door bracket to sides using 4
screws.
Door Bracket
attaches with
2 screws on
each side.
Double Screen Door: attach to left and right
side of unit.
2) Slide the door(s) onto the hinges.
Left Side
Faceplate Bracket
Trim Flange