Filter
Top Products
RCA L Version 2.0 17
5.4
Preparing the header assembly for
lifting
Loosen and remove the lower idler
barrel bolt (figure 5) and move the idler
barrel out of the way (figure 6) before
lifting the header assembly.
5.4.1 Lifting locations
There are eyebolts for lifting the
header assembly into place, located
on the header plates. Attach cable or
chain that is rated for the weight of
the header assembly. Be sure to
balance the header assembly before
lifting into place.
WARNING: The cable or chain used for
lifting the header assembly must not
exceed a 45°
°°
° angle from vertical
DANGER: A falling header assembly can
result in SEVERE INJURY and POSSIBLE
DEATH!
Installation
Figure 5
Figure 6
Figure 8
Figure 7