Filter
Top Products
31Quadra-Fire • Sapphire • 7055-116 Rev. D • 6/11
G. Positioning the Logs
While still breakable, the logs do not become fragile until
after the appliance is burned and they have cured. After
curing, any handling must be done with care as breakage
can easily occur.
PLEASE NOTE: Logs have been designed to work
specifically with the burner of this appliance. Exact
placement will ensure proper operation of your gas
appliance and reduce sooting.
Figure 8.11 Position rear log (#3) over the two locating pins.
Locating Pins
Place Log #3 over Locating Pins
1
Place upright
in depression
Figure 8.13 Place right front log (#1) into the depression. The
log sits upright and does not lean against log #3.
2
1
3
Figure 8.14 Place left front log (#2) into the depression. The
log sits upright and does not lean against log #3.
H. Mineral Wool
Improperly placed embers interferes with proper burner
operation.
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Explosion Risk.
WARNING
Figure 8.15 Apply dime size pieces sparingly along front
edge of burner. Do not block gas ports.
Place individual pieces of embers in front of and around the
gas log where they can be seen. Space them so that gas can
contact them on all sides. Try to avoid stacking the embers
on top of each other. This will assure maximum brightness
and effi cient use of the catalyst promoting brighter, cleaner
burning embers.
I. Embers
NOTE: Do not block gas ports.
Depression for Log #1
Depression for Log #2
Figure 8.12 Shows the depression locations for Logs #1
and #2.