Filter
Top Products
Page 4
7014-083C
October 26, 2006
R
CB1200-I Pellet Insert
R
R
E. Glass Replacement
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury
WARNING
F. Bafe Removal
1. Allow appliance to cool completely.
2. Open glass door.
. Grab the bottom of the bafes and pull up to dislodge
from hook attachment.
4. Use a standard screw driver to unlatch the covers
beneath the bafes of each side.
5. Re-install in reverse order.
Top & Bottom Frame
Door Latch
Side
Frame
Center Posts
Glass
Remove Door Latch First
and then Side Frame
Door Frame
shown with no
Glass or Glass
Frames
Remove 5 nuts from Bottom Frame
Figure 34.2
Figure 34.1
•
Remove door from appliance and place face down on
a protected surface to avoid scratching the door.
•
Remove all door rope.
Replacing Center Glass
NOTE: DO NOT LET Air Wash Spacers fall down from
top frame when removing and replacing center
glass.
1. Using a nut driver remove the (5) bottom nuts and
remove the bottom glass frame. Figure 34.2.
2. Slightly bend up and out of the way the 2 center posts
and slide the glass out the bottom.
. Slide new glass in, reposition the 2 center posts and
re-install bottom glass frame.
4. Re-rope the door.
Replacing Side Glass
NOTE: When removing the side glass with the door
latch, you must remove the door latch rst
before removing the side frame. Use a pow-
ered Phillips head screw driver to remove the
4 screws.
1. Remove side glass frame.
2. Loosen the top and bottom frame and slightly bend up
and out of the way.
. Slide glass out the side and slide new glass in.
4. Re-install the side glass frame and tighten the top and
bottom frames.
5. Re-install the door latch, if applicable, and re-rope the
door.
Top & Bottom Frame
Door Latch
Side
Frame
Center Posts
Glass
Remove Door Latch First
and then Side Frame
Door Frame
shown with no
Glass or Glass
Frames
Remove 5 nuts from Bottom Frame