Filter
Top Products
Page 22
7014-083C
October 26, 2006
R
CB1200-I Pellet Insert
R
R
7. Hold side curtains in open position and lower panel set
over insert setting lower edge of top panel in slot between
hopper lid and panel support as shown in Figure 22.1.
Place existing screw head (installed in Figure 21.2) into
locator hole in oor of insert. See Figure 22.2.
8. Lift hopper lid and press down on panel top while installing
(4) 8-2 x /8” screws into holes in panel support. (If screws
have been factory installed, tighten to secure panel to panel
support.) Return hopper lid to closed position.
9. Install a corner bracket on each side trim piece. Slide
brackets into top trim from each side and secure with
athead screwdriver. Attach trim assembly to panel set
as follows:
a. Ensure that brackets face towards the back.
b. Align trim assembly to panel set sides and slide
down.
Figure 22.1
Figure 22.2
Figure 22.3
F. Panel and Trim Set (Cont’d)
Figure 22.5- Completed View
View of "L" Bracket
installed
Figure 22.4