Filter
Top Products
R
R
R
October 26, 2006
7014-083C
Page 2
CB1200-I Pellet Insert
G. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance re, the
logs are not covered under warranty. Any placement vari-
ation other than shown here can cause excessive heat
and shall void the appliance warranty.
Figure 22.5- Completed View
1. Place the front log in rst as shown in
Figure 23.1. Place
log between repot and face of appliance with charred
area surrounding repot.
2. Set the left and right twigs onto the log, placing the holes
in the base of twigs over the locating pins in log. See
Figure 23.2. Ensure that the charred ends are facing
the repot.
LOCATING PINS
Charred Areas in the Back
Right Twig
Left Twig
Front Log
Figure 23.1
Figure 23.2
1. A 12 volt AC thermostat is required to operate this pellet
appliance. You may use the included wall mount thermo-
stat or purchase an optional programmable thermostat
or remote control. The included thermostat is equipped
with an adjustable heat anticipator. The current rating is
.05 amps. The anticipator needs to be adjusted to the
lowest setting available.
2. When mounting a thermostat on a wall, be sure to follow
your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for accu-
rate readings. The thermostat should be mounted on
an inside wall and not in direct line with the appliance
convection air. Remove any packaging from inside
the thermostat before using.
NOTE: If the thermostat is located too close to the
appliance, you may need to set the temperature
setting slightly higher to maintain the desired tem-
perature in your home.
. Open right side plane to access a 4 screw terminal block
located on the bottom right hand side next to the power
cord inlet. The center 2 screws are for the thermostat
wires. The outer 2 are the mounting screws for the ter-
minal block. Figure 23.1.
H. Thermostat Installation
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded prong
receptacle.
• Route cord away from appliance.
•
Do NOT route cord under or in front of appli-
ance.
CAUTION
Terminal Block
Center 2 Screws for
Thermostat Wires
Power Outlet
Figure 23.3